MOATES FLASH AND BURN DRIVER DOWNLOAD

MOATES FLASH AND BURN DRIVER DOWNLOAD

Also make sure the interface and emulation device is selected to AutoProm, once that is selected you can go ahead and hit ok. If you are sure your chips are not fake, contact us for further assistance. This is up to you. When in the software: You need to make sure the program you put in the chip ends up in the top end of the chip, so these settings matter.

Uploader: Nashakar
Date Added: 14 November 2013
File Size: 48.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 69617
Price: Free* [*Free Regsitration Required]

This reads the chip into the local buffer. If it passes a blank check, try programming it again.

Von Dutch thanks for the write-up Von Dutch! I first started the laptop up before I plugged in the burner to make sure that the New Hardware Found prompt would pop up.

Introduction

Verify Chip With Buffer – This will snd the contents of the chip at and between the locations specified in the “Chip Addressing” fields and compare them against the data in the buffer at the location “Buffer Addressing” field “Start Address. Programming chips with offsets comes into play in two situations: Blank Check – This will check the entire chip and return success if the chip is blank, or failure if the chip is not blank or upon error.

Everything was wrapped and neatly packed in the middle of the box. This can be tricky — there is a budn article on it to help you.

  INTEL GL960/GM965 CHIPSET - GRAPHICS CONTROLLER 0 C-0 DRIVER

If that happens then you have successfully setup the chip burner and software and ready to burn you some chips. It should be noted that this will erase the entire chip. You asked, we deliver! Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional. Switching adapters use chips that are larger than an ECU requires, allowing the extra space to be used for multiple programs.

Take note of the file size indicated in the message window.

Flash N Burn « Moates Support

Both of these cases will be covered in this article. The following table summarizes what offsets you need to use depending on chip used and file size: If the chip you are programming is of a larger capacity than the binary file you are putting on it, you need to use an offset to ensure the tune ends up in the right spot on the chip. Make joates it says device enable, then click port settings tab, then click the advanced button located in the middle. Burning a chip From File – To burn a file to a chip: Re-erase and blank check it.

Read Chip – This will perform the action of reading the chip. The chip gets read into the buffer, then the buffer gets saved to file. You can use the standalone Flash-N-Burn software located at http: This is up to you.

  MICRODIA FLASHMOVER 16-IN-1 DRIVER DOWNLOAD

Flash & Burn Program for BURN1/2/Jaybird+APU1

Install the chip per directions printed on the burner — the unused pins should be closest to the metal handle. Reading a chip To File – To read a chip to a file: Erase Chip – Pressing this will erase the entire contents of the chip from beginning to end. These settings are important because most of the chips used in ECUs are a smaller capacity than the chip you are programming.

Remove it and re-insert it to be safe. If your burner fails to erase several different chips, you probably have fake chips. We will be selecting the correct flsah and chip addressing to ensure the chip is burned properly and can be used.

Load File To Buffer – Pressing this button will bring up an expolorer dialog to select a file with which to fill the buffer.

Moates BURN2 Chip Burner – Programmer

Select it, and it will be loaded to memory on the PC. Some adapters have chips which can hold more tunes than there are address budn for switching. From File – To burn a file to a chip: