The applications relevant to your product will now be shown and will begin to install: Make sure that the latest drivers for your VGA card are installed as well. Microsoft is aware of these types of issues with capture devices. Upon reboot, plug it in again and try WinTV again. Windows will detect the card when you reboot and should reassign the resources for it. Most third party capture applications are looking to attach to a card or driver that supports uncompressed video recordings.

Uploader: Mok
Date Added: 9 September 2008
File Size: 62.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 5692
Price: Free* [*Free Regsitration Required]

Make sure your graphics card supports Overlay. This should get the video to display. Open WinTV and try adding a channel and see if the video and audio play. In order to stop the MCE services go to hauppauuge task manager and to processes and end the following tasks if they are running: WinTV and all of its functions work fine until the system is rebooted.

Hauppauge Support | WinTV-PVR-USB2

If the software is installed but you are unable to open or control the WinTV software with the remote control, the device may need to be wuntv. Supports the latest Hauppauge TV tuners: When windows comes up again, it recognizes the card as a new device and must be reinstalled in order to work again.


If it is not listed, this would normally indicate that the hardware was not recognized by the system and the drivers were unable to install. You can also turn off Video Out in the same menu selection.

This is a single file which includes the driver, the driver update, middleware, video decoder and WinTV v6 applications and all accessories. Once complete, proceed with the installation as normal. The only way to reset the device is to recycle the power to it by unplugging the vitsa from the power cable for a few seconds then re-plugging it. You will need to reboot the system during installation. You may need to upgrade the video card drivers or change your viista.

Select Force Primary and close the Primary program out. This error will occur if Overlay is not working properly on your system. Recycle the power to it by unplugging the unit from the power cable for a few seconds then re-plugging it. To correct this error, run the PVR48xxx. If you get a Black screen after scanning for channels, but you can hear the audio, try closing and reopening the program. The driver for the device must be installed in order to run Prodinfo.

This hauppahge ensure that all left over files from the older model are no longer on the system. Initial installation was smooth, and finished without any problems.


Support: WinTV-PVR-USB2

Once installation finishes, you should be able to use the program. Downloads and documentation are available at http: This error message can indicate a problem with the Driver installation or a hardware malfunction. It will use software decoding for the playback and pause functions.

If you would like to read the Microsoft Knowledge base article concerning the hyper-threading fix you can click the following link.

Hauppauge Support | WinTV-PVR and WinTV-PVR

There should be a fix for this in Service Pack2: Also, be sure that the VGA cards hardware acceleration settings are on Full.

If video does show up, the device is good. There should be a fix for this in Service Pack If it is, unplug the power from the unit and restart the computer. In the Performance section click on the Settings button, then the Advanced tab.

Hauppauge WinTV-PVR-150 Free Driver Download

This will then open up our driver installation program and automatically start installing the drivers for your product:. A Pentium II Mhz minimum is required.

Try inserting the channels manually to see if the video comes up.