Because the printer cannot print any transactions, the data may be lost. The supports the industry standard RSC communication interface. Slip 1B 32 27 50 ESC 2. By pressing ‘print’ button you will print only current page. Paper feed button is not pressed.

Uploader: Kajit
Date Added: 18 October 2010
File Size: 40.72 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 25182
Price: Free* [*Free Regsitration Required]

Remote power supply Power and communication support for a remote 2×20 pass-through display Two cash drawer kickouts Audible tone controlled by application Note: Micr Not Reading Properly If paper is not low and no conditions indicate that the thermal printhead is too hot, zxiohm it is likely that the power supply voltage is out of range.

Minutes Tenths of seconds Sets the time in m minutes that the printer waits for a slip to be 71566 into the slip station. The command is not valid with Single or Axohm Density graphics. It is the only way to run the print test on the slip station. When this command precedes a logo print command, and n is different from the previously active logo selected, the printer will retrieve the logo definition for n from flash and print it. Crating is included and pallets are professionally boxed and shrunk.

If the terminal indicates an incorrect read of aixohm MICR: See the illustration on page 16 for the position of the DIP switches. Bits are not used.



This is a completely new feature, and new commands handle reads, writes, and memory management. Keep the slip from moving during the procedure. If something appears to be wrong with the test printout such as sxiohm or faded text additional troubleshooting and diagnostic guides are available.

Qxiohm RealPOS printers are designed to provide superior reliability, advanced feature functionality, and are supported by Systemedia’s extensive line of printer supplies.

Thermal user-defined characters written to flash. Enter text from picture: This command can be used with built-in characters and user-defined characters, but does not affect the space between lines. All commands and data sent from the host axjohm will be printed as hexadecimal numbers as shown in the illustration.

The existing Transmit Printer ID command is extended to provide the new remote diagnostics feature.

Axiohm 7156 Black Ribbon For NCR 7156 Seamless

While flash is being erased, the printer must disable all interrupts, including communications. If you have not taken the roll out, continue with the following instructions. The command remains in effect until the printer is reset or the Clear Printer 10 command is received.

The Rotated Print command 1B 12 cancels this command. Printer is Busy at the RSC interface. Transmit Cash Drawer Status Transmits the current status of the cash drawers. Command List This section groups the commands according to the following categories: The application must also allow output lines to be buffered ahead 71556 the printer, so the printer will be able to print each line immediately after the preceding line, without stopping to wait for more data.


Setting Up and Using the Printer Axiom a Location The printer takes up relatively little counter space and may be set on or near the host system.

The printer can be set through the DIP switches to ignore or use this command.

AXIOHM 7156 Thermal 3 1/8 Inch x 230′ Paper 50 Rolls

Item Type Power supply with attached cable to printer and U. Close the front cover. Setup Qxiohm Cash Drawer Cables The cash drawer cable connects the printer to one or two cash drawers.

Horizontal Value of y: Only one horizontal pitch is available: Using the Printer 2. Box Appleton, Wisconsin Voice: